|
产品说明 Description |
|
IE50是由丙烯酸共聚乳液、颜料、填料和助剂等组成的水性外墙涂料。该产品具有优良的耐水耐碱性，漆膜坚韧，附着力强，用于外墙具有优良的耐久耐候性。
High quality exterior emulsion paint IE50 is a water-borne coating, which consists of acrylic copolymer emulsion, pigments, fillers and additives etc. It forms a hard and tough film resistant to water, alkali. Remarkable adhesion and long-lasting weathering resistance provide protection for exterior walls. |
|
主要特性 Outstanding Characteristics |
|
本品可涂于三合土、灰泥、混凝土、水泥石棉板等表面，用于内外墙装修。尤其适合于住宅、商业楼宇、厂房等内外墙的装饰和保护。
On the surfaces of concrete, stucco, cement, cementitious sheets. For interior and exterior walls. Especially for interior and exterior decoration and long-term protection, such as housing, commercial buildings, factory buildings etc. |
|
技术数据 Technical Data |
|
漆 面:
Finish: |
无光
Flat |
|
颜 色:
Colors: |
白色 （其他颜色参照色卡）
White（other color according to colors card） |
|
体积固体含量:
Volume solids: |
约36%
Approx.36% |
|
理论涂布率:
Theoretical spreading rate: |
约8.0米2/升 (以45微米干膜计)
Approx. 8.0 m2/L (45 microns dry film thickness) |
|
闪 点:
Flash point: |
无
None |
|
比 重:
Specific gravity: |
约1.5千克/升
Approx. 1.5 kg/L |
|
指 触 干:
Dry to touch: |
3/4小时
3/4 hour |
|
施工详述 Application Details |
|
施工方法：
Application method: |
刷涂、滚涂
Brush、Roller |
|
稀 释 剂:
Thinner: |
淡水
Fresh water |
|
用量:
Max.: |
20%
|
|
工具清洗
Cleaning of tools: |
清水
Fresh water |
|
漆膜厚度:
Indicated film thickness: |
湿膜:125微米
Wet: 125 microns |
干膜:45微米
Dry: 45 microns |
|
重涂时间:
Recoat interval: |
最小:2小时
Min.: 2 hours |
:不限
Max.: none |
|
表面处理:
Surface preparation:
|
被涂表面必须清洁、干燥、无油。结构应平整、坚实、不起粉。遇有旧漆膜的墙面，应将粉化、剥落的旧漆清除干净，并用砂纸打磨墙面。若墙面霉菌滋生，须用漂白粉溶液反复清洗干净，彻底清除霉菌，并用清水冲洗干净，待表面干燥后，方可涂漆。 |
|
|
The surface must be clean, dry and free of oil and grease. The structure should be smooth, solid and free from chalking materials. Remove all loose, flaking materials from previously painted surfaces and roughen them with sandpaper. Walls with mould should be |
|
|
washed with bleaching solution, followed by fresh water. Allow the surface to dry before overcoating. |
|
施工条件:
Application conditions: |
按照正常良好的条件进行施工。
As dictated by normal good painting practice. |
|
注意事项:
Notices for application: |
1. 本产品应存放于阴凉、干燥、不受日光直射的仓库中，不可储存于0℃以下。
2. 温度10℃以下或湿度85%以上不宜施工。
3. 本品使用时无须加水即可施工，若漆过稠，允许加入少量清水，漆量5-10%,但不得加入其它油漆及有机溶剂。
4. 墙面表面松散并严重脱粉的情况则不宜施工。
5. 对新落成的建筑物要特别小心, 因为墙面碱性可能太强, 过早施涂将致起泡以至脱落。墙面碱度应当在PH<10 条件下才可施工。
1. Store in a cool, dry place without direct sunlight. The temperature must be above 0℃.
2. Do not apply when temperature is below 10℃or relative humidity is above 85%.
3. It need not add water when application. If paint is too thick, thin down by adding fresh water that is 5-10% of paint. Do not mix with other paint or organic solvents.
4. The application should only be carried out when remove loose and chalky materials on the surface.
5. Be careful with new buildings, because alkali on the surface may be too strong, earlier coating will result in blistering, even peeling. The application can be carried out, provided the alkali on the surface has a PH value below 10. |
|
备注 Remarks |
|
可以根据使用的目的及部位改变漆膜厚度。随之涂布率、重涂间隔和干燥时间也会相应改变。本品无重涂间隔。如重涂前施工表面受过污染，须用高压淡水冲净表面, 任其自干后，再进行重涂。
潮湿表面定义：表面上有水分但肉眼不易看出。
May be specified in another film thickness than indicated depending on purpose and areas of use. This will alter spreading rate, recoat interval and drying time. No maximum recoat interval. Before overcoating, the surfaces exposed in polluted environment must be thoroughly cleaned by high-pressure fresh water. Allow the surface to dry.
Definition of damp surface: Damp surface means the surface on which water is not readily detectable. |
|
安全 Precautions |
|
本产品在施工时应遵守有关的国家卫生，安全和环境标准及其法规。使用前应获取和咨询有关本产品的材料安全数据表。注意包装标签上的安全事项。如果你没有完全理解或你不能严格执行这些安全事项，不要使用本产品。
在施工和干燥期间要采取通风措施，维持溶剂蒸汽的容度在安全极限内，防止中毒或缺氧。小心避免与皮肤、眼睛接触。
All work involving the application and use of this product should be performed in compliance with all relevant national Health, Safety and Environmental standards and regulations.
Prior to use, obtain, consult and follow the Material Safety Data Sheet for this product concerning health safety information.
Read and follow all precautionary notices on the Material Safety Data Sheet container labels. If you do not fully understand these warnings and instructions or if you cannot strictly comply with them, do not use this product. Proper ventilation measures must be provided during application and drying to keep solvent vapor concentrations within safe limits and to protect against toxic or oxygen deficient hazards. Take precautions to avoid skin and eye contact (i.e. Gloves, goggles, face masks, barrier creams etc.)
Actual safety measures are dependant on application methods and work environment. |
|
附注 Other Notice |
|
本说明书有关数据是在标准条件下取得，实际使用时，环境条件可能与之略有不同，以上数据如有改变，以本公司说明书为准，恕不另行通知。
All information in this product data sheet is based on standard conditions and slight variation may occur with different conditions. All information in our company is subject to change without notice. |